If the engine is running the driver's door opens, and the brake pedal is pressed, issued a warning beep: you should move the gearshift lever in position N and tighten the parking brake. When you stop on the rise should be sure to tighten the parking brake pedal or press the main brake. Do not hold the car when the transfer by increasing the engine speed to prevent overheating of the gearbox. When excess heat traction automatically. For longer stops, such as in a traffic jam or on the move, turn off the engine. Installation of car parking Before leaving the car tighten the parking brake, then remove the key from the ignition. Inclusion of the last channel (the display on the indicator gear box) is enabled. In position N transfer is not included. After turning off the ignition Easytronic transmission ceases to respond to the movement of the gear lever. If you do not remove the ignition key, then long-time parking your car can happen discharging. If not tightened the parking brake, within a few seconds after the ignition is turned off alarm flashing parking brake system. If the engine is off and parking brake nezatyanutom opened the driver's door, issued a warning beep and flashes the same detector. In this case, turn on the ignition, including transfer, then turn off the ignition and tighten the parking brake. Pulling the car when slips To pull a car stuck in sand, mud, snow or a ditch, with a little throttle translating the gear lever back and forth between the provisions of the R and A (or + and -). If possible, hold the engine at low speeds and avoid falls when you press the accelerator pedal. NOTE The above method is used only in those exceptional cases. Precise maneuvering For precise maneuvering, such as the installation of parking, check-in garage, etc. You can use the property of "sliding" enabled the transfer when you release the main brake pedal. Do not squeeze the accelerator and brake simultaneously. To protect against damage Easytronic transmission overheating clutch function of "sliding" switch off automatically.
Driving a car with automatic transmission After starting the engine before turning on the transfer, press the brake pedal. When the transmission and the brake released, the car starts moving. Do not press both the accelerator and brake pedals. While D can ride in almost any conditions. With a soft uniform squeezing the accelerator pedal is timely gear changes, providing fuel economy. Manual switching is necessary only in exceptional cases. Third, second or first choose a transfer only if switching to higher transfer undesirable, or when engine braking. How to only allow traffic situation, switch back to mode D. Indicator gearbox Fig. 1.221. Indicator automatic transmission
98
