Replacing the front damping arm bushings

Fig. 4.36. Installing a new ring: 1 -

snap ring, 2 - adaptation

Attach the new circlip using appliances KM 6384 (Fig. 4.36). Set a rack in a spring swivel fist. Install 2 bolts.

NOTE Install the bolts in the front. Do not tighten up camber of the wheels.

Use 2 new bolt. Use 2 new nuts. Attach a swivel arm for supporting the pipe rack and tighten the spring element 65 Nm Use new nut. Hold for Lyskov open wrench. Attach the brake hose to the bracket supporting the tube spring rack.

NOTE Correctly lay the hose.

Install the brake hose bracket. Attach the brake hose using a clamp. Install the sensor spring rack CDC to mount the sensor on a spring rack. Tighten the attachment bolt. Install the wiring harness on a spring rack. Attach the wiring harness in the clamp spring rack. Connect 4 x wiring harness to the wiring harness. Turn the secondary locking mechanism. Slide the locking mechanism up. Install the front wheel and tighten the bolts fastening point 110 Nm Check and adjust the collapse of the wheels. Check and adjust the collapse of the wheels. 2 Tighten the hinge that supports the spring the pipe rack to the steering knuckle, in 3 hours. I. Tighten the 2 bolts moment 50 Nm II. Tighten the 2 new joint torque 85 Nm III. Dauvergne 2 new joint by 75 ° and +15 °.

NOTE In the general case, both damping bushings must be replaced. ,

Withdrawal

Remove the lever.

Vypressuyte front damping sleeve with Specials instruments KM-508-A-1 and KM-508-A-3 (Figure 4.37).

Setting

Cover the front damping sleeve (1), adaptation of KM-508-A-2 and the lever soapy water before mounting.

Fig. 4.38. Mounting the front damping sleeve: 1 - damping sleeve, 2, 3, 4 - a special tool

Zapressuyte front damping sleeve with special devices KM-508-A-3, KM-508-A-2 and KM-508-A-1 (Figure 4.38). Install lever. Replacing the rear damping arm bushings

NOTE In the general case, both damping bushings must be replaced.

Withdrawal

Remove the lever. Attach special tool MKM-6615-10 to the lever. Attach MKM-6615-12 to MKM-6615-11. Attach special tool KM-6005-2 to the special adaptation MKM-6615-11 and MKM-6615-12 from the ring.

Fig. 4.39. Extrusion rear damping

sleeve: 1, 2, 3, 5, 6 - a special tool, 4 - damping bush