Replacing the external velocity joints

Mount the joints of equal angular velocity in a vise with soft lips and insert the drive shaft. If the shaft is not included in the hinge, zapressuyte hinge on the shaft on the press, with the shaft bottom must rely on the support (Fig. 3.111). Set the groove shaft new spring-loaded locking ring. Fill the inner hinge 120 grams of lubricant, with one half of lubrication in the joint mortgage on the one hand, and the second half - the other side. Replace the protective cover. Before mounting a protective cover with clamps, screwdriver, lift the inner edge of the cover, to equalize the air pressure under the cover.

Remove the clamps mount a protective cover and slide the cover to hinge on the driving shaft. Thoroughly clean the inside of the hinge and remove the spring-loaded locking ring on the inside hinge.

Fig. 3.112. Removing the hinge to

the drive shaft

Attach the drive shaft in a vise with soft sponges and aluminum or copper with a hammer Destroy joint with drive shaft (Fig. 3.112). Remove the spring-loaded locking ring, gasket and plate washer from the end of the shaft. Fill the inner hinge 90 grams of lubricant. Install the drive shaft plate washer, convex side to the hinge. Install the new drive shaft, spring-loaded locking ring, secure the shaft in a vise with soft lips, and an aluminum or copper hammer nabeyte hinge on the drive shaft, and the retaining ring must clearly fall into the groove on the inner side of the hinge.

Fig. 3.113. Mounting clamps