Removal and installation of coolant pump

Remove the condenser from the radiator by unscrewing the bolt fastening 3 (Fig. 2.263). Mount the capacitor with intercooler. Remove the 2 radiator holder from the bracket. Carefully remove the radiator from the bottom.

NOTE Be careful not to damage the fins.

Setting

Install radiator below. Install 2 of the holder of the radiator bracket. Set 2 of the holder of the radiator bracket. Disconnect the capacitor with intercooler. Attach the condenser to the radiator. Tighten the 3 bolts. Attach the hose to the radiator air pressurization Attach the clamp and tighten the bolt. Attach the wiring harness to the radiator air conditioning. Attach the cable clip. Lower the car in half Connect the lower radiator hose to the radiator and attach the clamp. Attach the upper radiator hose to the radiator and attach the clamp. Install the fan. Attach the coolant hose bracket. Attach the fan to the radiator and tighten the two bolts. Attach the intercooler to the condenser, and tighten the two bolts. Attach hose-back from the turbocharger coolant to the radiator and tighten the clamp. Fasten vozvaratny hose bracket. Connect the boost pressure sensor. Install the hose between the boost air duct pressurization and intercooler. Raise the car completely. Set the left and right brackets radiator. Tighten the 4 bolts fastening point 15 Nm Attach the wiring harness to the fan the fan. Attach the cable clip. Attach the wiring harness connector. Lower the car in half. Install outdoor sensor to the mounting Attach the hose of the cleaner high pressure to the reservoir. Connect the quick coupling. Install the front bumper. Remove the 2 radiator holder from the bracket. Install radiator grille. Connect the battery pack. Attach connection with a mass at the conclusion of mass. Fill coolant and adjust the level of coolant. Program temporary memory. Close the hood.

Withdrawal

Remove the timing belt Lift car. Drain the coolant. Tighten the drain bolt. Lower the car completely