Power windows

To open the hood, pull the handle to unlock the hood from the driver's espoused under the dashboard (see Figure 1.28). Castle is unlocked, and the hood will open slightly. Return the handle to its original position.

Fig. 1.29. Opening bonnet

At the bottom of the hood latch handle is - then it up and open the hood (Fig. 1.29).

NOTE Be careful: the mud or snow, located on the hood, when opened, can fall on the windscreen and clog the air intake.

Hood is automatically kept in the open position. To close the hood, pull it down and give it slammed shut. Check the fixation of the hood, pulling it over the front edge. If the hood is not, repeat the previous operation.

Electronic control window

Electronic control window work when the ignition key. In addition, the functions of windows continue to work within 5 minutes after the ignition is turned off and within 5 minutes when you turn the ignition key to position 1. When you open the driver's door using the function becomes impossible.

Central Control Panel window

Fig. 1.30. Opening bonnet

Central Control Panel window is located on the driver's door (Fig. 1.30).

The front keys are designed to control the glass on the doors of the driver and front passenger. Rear keys open and close the glass rear door. Additional control buttons are located on the front passenger door and rear door panels. For the gradual movement of the glass, briefly press the forward or backward. To automatically open or close hold the keys pressed so far as is necessary.

Safety function

In the case of resistance during the automatic closing of glass above the middle of the window movement immediately stopped and the window re-opens. If tugogo progress, for example due to the presence of frost, repeatedly press the key corresponding to the window until it closes.

Lock opening rear windows

To lock, press the switch between the rear buttons on the handle of the driver's door (Fig. 1.31).

Fig. 1.31. Key lock rear windows

If you press the switch forward (see red box) - glass rear doors are blocked. If you press the switch back (see green box) - glass rear door unlocked.

Faulty windows

If the automatic opening and closing windows is not possible, an electronic management system windows must be activated. To do this, close the doors, turn on the ignition and open the windows. Then close the window and hold not less than 5 seconds.

NOTE The procedure is repeated for each window separately.

Panoramic glass

Fig. 1.32. Opening panoramic

glass

To open the panoramic windows, turn the knob to the right and slide back into the right position lining the ceiling (Figure 1.32).

Fig. 1.33. Closing the panoramic

glass

Sunroof NOTE You move the ceiling sheathing fold sun visors up.

Fig. 1.34. Keys hatch on the roof

Luc control keys on the console on the roof (Figure 1.34). For the gradual movement of the hatch, press the button briefly. To automatically open or close hold them pressed. Lifting the hatch. In the closed hatch, press , Hatch rear its rear. Opening the hatch. In the raised position to re-press , The hatch is fully open. Closing the hatch. Press . Because of the open hatch closed, for security reasons do not reach 20 cm to the end. to completely close it, hold the key pressed.

Sun blinds

Sun blinds designed to ensure that the sun's rays do not penetrate into the salon with a closed sliding hatch. When you open the hatch opens and sun blinds. Opening curtains. Press , Shutter is fully open. Closing the curtain. Press , Shutter is fully closed. From the open position shutter is closed for security reasons, do not reach 20 cm to the end. For a complete closing of the shutter, press and hold .

NOTE With the luggage on the roof, to avoid damage, make sure you have enough space to move the sliding hatch.

If a sliding sunroof and sun blinds do not work, you must activate the electronic system. To do this, turn on the ignition, close the sliding hatch and hold down at least 10 seconds. Close the sun blinds and hold down at least 10 seconds.