Removal and installation of the main shaft (gearbox F 13

NOTE Note the similarity of the bolts.

Attach the rear cover. Replace it with a new gasket on the transmission housing. Tighten the 4 bolts M7 moment 15 Nm Tighten the 5-bolt M8 moment 20 Nm Set shafts of the wheels. Check the fluid level in the gearbox.

NOTE Transmission is installed.

Withdrawal

Remove the gearbox. Remove the switch reversing lamps. Disconnect the wiring harness connector, switch reversing lamps. Remove the casing front axle.

Fig. 3.83. General view of the main

shaft and the mechanism of synchronization: 1 - Leading 2-nd gear transmission, 2 - inner synchronizer ring, 3 - intermediate ring, 4 - outer synchronizer ring, 5 switching hub; 6 - Spring synchronizer; 7 - sliding blocks, 8 housing synchronizer; 9 - Leading pinion 1-th transmission

Remove the back cover by unscrewing the mounting bolts 9.

NOTE If necessary, loosen the fastening lid light strikes a rubber hammer.

Remove the rear cover gasket. Remove the back cover. Remove the main shaft.

NOTE If the gears are damaged, the entire block of gears must be replaced.