Removing and installing the flywheel (engine 2.0 liters

Lock the flywheel using a special device KM-652. Loosen the mounting bolts 6. Check the rear oil seal of crankshaft, flywheel and flywheel gear ring for damage or wear, replace if necessary. Clean the contact surfaces of the crankshaft and flywheel.

Setting

Install the flywheel on the crankshaft.

Fig. 2.161. Install the flywheel: 1 -

Handwheel, 2 - a special device, 3 bolts fastening

Block it with a special device KM-652 (Fig. 2.161). Clear 6 threads. Tighten the 6 bolts (3) point of 35 Nm, Dauvergne at +30 °.

NOTE When installing, use new bolts.

Apply (red) for the fixing of the threads. Replace the clutch housing. Set the gearbox.

Withdrawal

Remove the manual transmission. Remove the clutch. Remove the flywheel from the crankshaft.

Fig. 2.162. Locking wheel when

removing: 1 - a special device

Block with a special device KM 652 (Fig. 2.162). Loosen the 6 bolts Clean threads