Three-way security system

Retraction of the belt inertial reel can be difficult if the strap and the intermediate guide bracket contaminated. So check to see that portion of the belt and the guide bracket were clean (Fig. 1.206). If the seat belt drawn on the coil, it will work in emergency mode locking. In this mode, a safety belt does not violate the convenience of passengers. In the case of collision inertia reel blocks the issuance of safety-belt that holds the passenger in place. If fully stretch belt with a coil, then it switches to auto-lock belt. If there is a strong belt tension, or it impedes the movement of the passenger on a stationary car or while driving, the possible reason for switching is an inertia reel in the auto lock mode, after the belt was too long from the coil. In order to return the inertial reel in a more convenient mode of interlocking safety, stop the car in a safe place on a horizontal platform and fully Pass the belt inertial reel. This coil switches to emergency locking belt. Then, pull the seat belt to the required length, in order to buckle up.

The structure of this system include: - Three-point belts; - Stoppers seatbelt in the front seat; - Airbag system for driver, front passenger and rear outer seats. Depending on the severity of the accident components of the three-tiered security system vlyuchayutsya alternately. Auto lock safety belt prevents the extraction of belt that allows you to keep the passengers in the seats. Castles in the front seat belts drawn back. Due to this safety belt immediately adjacent to the body, which reduces the load on the body. Systems airbags triggered further in severe accidents and form a protective cushion for passengers. Actuation of the front airbags are depending on the severity of the accident in two phases.

Seat belts

Fig. 1.207. Installing belt

Evenly pull the belt reel, and not perekruchivaya, drag it over the body.

Snap the tongue of the buckle, lock (Fig. 1.208). The back of the front seat should not be tilted too far back, as it adversely affects the performance of safety belts. The recommended angle is about 25 °. Lap belt should fit snugly to the body without twisting. During the visit it from time to time should be tightened, pulling the shoulder strap. Belt (especially when seat-pregnant women) should take place as far as possible down the thighs to avoid pressure on the lower abdomen. A thick layer of outer clothing violates close fitting belt. Belt not impose on the firm or fragile items in the pockets of clothing (eg, keys, pens or glasses), as this can lead to injury. Between the belt and the body should not be any items such as handbags or mobile phones.

Adjusting the height of the upper guide element of the front and rear seat belt

Lightly pull the belt. Press the down button on the sliding regulator. Move the slide knob up or down. Lock the sliding knob until it clicks tangible.

NOTICE Do not adjust the height of the belt during the movement.

Fig. 1.209. Adjusting the height of

the upper guide element of the front and rear seat belt

Adjust the height of the belt so that it passed through the shoulder and tight to him. Never belt should not pass on the neck or upper arm.

Removing the belt

Fig. 1.210. Removing the belt