Removing and installing wheel bearing

Withdrawal

Turn off the parking brake systems.

Fig. 4.48. Reducing the parking

brake cable: 1 - hand brake lever, 2 cover hand brake lever, 3 adjusting nut

Release the handbrake lever (1) and disconnect the hand brake lever cover (Figure 4.48). Loosen the parking brake cable adjusting nut return. Remove the rear wheel. In cars with drum brake mechanisms: remove the brake drum.

NOTE To prevent the fall of the brake shield and damage the brake line, tie the brake line to the back of a spring near the brake wheel cylinder, using cable ties.

In cars with disc brakes: unplug the cable from the parking brake caliper brake. Take control lever caliper brake mechanism with a screwdriver. Remove the parking brake cable system. Remove the clamp. Pull the parking brake cable from the bracket. Remove the brake caliper with brake suspension of the base plate.

NOTE If not possible to withdraw caliper brake mechanism to guide and brake pads from the brake disc, for example, due to wear of brake disc: remove the brake pads rear wheel brake mechanism.

Unscrew the 2 screws fastening the suspension of the brake mounting plate. Take the caliper brake with a guide from the brake disc. Hang the caliper brakes and rear spring guide to using a suitable wire. Remove the brake disc rear wheel. Attach the mounting plate to the rear spring, using the cable styazhkie Disconnect the wiring harness connector from the sensor installed on the wheel of the car. Disconnect the module from a wheel bearing rear axle.