Replacing the damping body fuel return

NOTE At this point, absolute cleanliness is essential.

Install clamp fastening the fuel pressure regulator and attach the fuel rail, tighten the moment of 5 Nm Connect the vacuum hose to the fuel pressure regulator. Remove the cap turbocharger inlet pipe. Attach the vent hose to the lid of the engine cylinder head and attach the clamp. Connect the inlet pipe to the turbocharger. Connect the inlet pipe to the air intake hose. Tighten the attachment bolt clamp.

Withdrawal

Open the hood. Disconnect the battery. Disconnect the grounding connector on the grounding clamp. Remove the engine.

Fig. 2.281. Components damping

body vozvarata fuel: 1 - Hoses 2 damping case, 3 - oil line 4 - the return fuel line

Remove the fuel return damping case (Fig. 2.281). Remove the return fuel line with a special tool KM-796-A. Remove 2 hose. Remove the 2 clamps. Disconnect the oil line. Loosen the 2 bolts (arrows in Figure 2.281).

NOTE If the oil line is disconnected from the damper body, it should be replaced.

4 Remove the oil line. 4 Remove the clamp (arrows in Figure 2.281)

Setting

Install oil line. Connect 4 oil line to the fuel injectors. Attach the damping body fuel return. Attach the oil line. Attach the return fuel line. Attach the hose 2. Install 2 tie. Tighten the 2 bolts moment 9 Nm Replace the cover of the engine. Connect the battery pack. Attach the grounding connector to the grounding terminal. Program volatile memory. Close the hood.