Wipers and washers

Care wipers

Fig. 1.105. Window rain sensor

In order to ensure trouble-free operation of rain sensor, window sensor must be clean from dust, dirt and ice, so periodically switch the device washing windows or remove ice from the window of the sensor. Vehicles with rain sensor has a window above the sensor on the windshield (see Figure 1.105).

Job wipers

Fig. 1.106. Mode include wipers

To activate the wipers move the lever up slightly (Fig. 1.106). The lever always returns to its original position. to switch the lever to the next higher or lower stage, slightly move it up or down. To enable a single lever, slide down from the position .

Adjustable range of wiper

To adjust the cleanup interval in the range from 2 to 15 with a turn on the ignition, move the lever from the position down, wait for a while and move the lever in the position of the periodic inclusion. The installed length of the interval treatment remain stored in memory until the next change or until the ignition is turned off. After turning on the ignition and set the lever in position interval inclusion is set at 4 seconds.

Fig. 1.107. Adjustable range of

wiper

To activate this mode, slide the lever up slightly, then enable automatic management of cleaning with rain sensor. In this mode, rain sensor determines the amount of water on the glass and automatically adjusts the speed of the wipers. To turn off the regime pull the lever down.

Fig. 1.108. Mode for automatic control wipers with rain sensor

Switch the device washing windows and headlights

To activate this mode, pull the lever for him. Wipers included several cycles of treatment. At low speed One-time cleaning. Cleaning device works when the headlights illuminated. The washing liquid is sprayed on the lights, after which the device is flush headlights off at 2 min.

NOTE On cars with rain sensor to monitor the cleanliness of the window sensor.

Fig. 1.109. Mode devices include washing windows and headlights

Inclusion wiper and rear window

Fig. 1.110. Inclusion of the rear

window wiper

To activate the wipers push the lever forward (Fig. 1.110). Rear window wiper works in periodic mode. Rear window wiper is automatically enabled when working wipers and going backwards. To activate the windshield of the slide lever forward and hold.

Fig. 1.111. Installing the

windshield in the upright position

Before you replace or clean the brushes front windshield, within 4 seconds after the ignition is turned off, without removing the key, slide down the windshield wiper lever. Release the lever when the windshield wipers will take a vertical position (Fig. 1.111). To remove the brushes lift the wiper arm, rotate the brush at 90 ° with respect to the lever and remove it.

Fig. 1.112. Removing brush the

front wiper

Fig. 1.113. Removing the rear

wiper brushes

To remove the brush, lift the rear wiper arm wiper. Disconnect and remove the brush, as shown in Figure 1.113. Cover fuel filler When replacing only install brand cap, which was released by Opel for the model of the car. Motor vehicles with diesel engines installed a special cover of the fuel tank.

Filling the car with fuel

Before dressing sure to turn off the engine and, if necessary, additional heaters with combustion chambers (indicated on the sticker on the cover fuel filler). 55

NOTICE In dealing with fuel is not permitted near open flame or spark formation. Do not smoke. This also applies to the places where fuel availability is noticeable only by its characteristic odor. If you smell fuel in the cabin should immediately remove the cause of its appearance.

Filling hole is situated to the right side of the car behind. Filling hatch simultaneously with the doors unlocked. Open the filling hatch by turning the filler cap of the fuel tank, remove it and hang it on the filling hatch.

NOTE The fuel tank has a fill limiter which prevents overfilling of the tank.

Fig. 1.114. Hatch lid and fuel filler

To implement the correct filling must be able to handle the nozzle. Insert the nozzle to stop and turn it on. After the automatic shutdown is performed to re-dosed refueling prior to the nominal capacity of the fuel tank. Nozzle, however, remains stuck until it stops. To close the fuel filler lid, set it in place and rotate, overcoming resistance to tangible clicking striker. Close the filling hatch.

Parking Brake

Fig. 1.115. Delayed styanochnogo

brakes

On a slope or on the rise always tighten the parking brake is the most dense (Fig. 1.115). Mechanical parking brake acts on the brakes the rear wheels. When tightening, he recorded independently.