Replacing the steering mechanism (TRW

Setting

Attach the steering pull to the steering mechanism and tighten the moment 90 Nm Clean the threads on the rail and cover with a fixing composition. Attach the steering pull to the rail with a special tool KM-6004-2, and hold an open wrench for Lyskov on rack (arrow in Figure 5.27). Replace cover or covers. Install the appropriate tip steering traction. Check the position of the rectilinear movement, adjust if necessary. Check the convergence of the wheels, adjust if necessary.

NOTE To remove the steering mechanism must be removed the front suspension subframe.

Withdrawal

Remove the front suspension subframe. On vehicles with left-hand steering clear bracket damping engine block rear damping block engine. Remove the holder.

Fig. 5.28. Removing the pipe from the steering meanizma: 1 - bracket damping engine block, 2 - holder, 3 - supply pipeline, 4 - return pipeline

Remove the supply pipeline and the return pipeline from the steering mechanism (Fig. 5.28).

NOTE To use the resulting oil tray.

Wiring harness and unleash the power steering of the front suspension subframe.

NOTE Pay attention to the laying bundle.

Remove the electrohydraulic module with the front suspension subframe.

Fig. 5.29. Mounting

electrohydraulic module: 1, 2 - Nuts

Fig. 5.30. Removing the steering

rods: 1, 2 - Fixing brackets, 3 - nut, 4 - tie rod ends

Disconnect the 2 tie rod ends from the steering mechanism by means of devices KM-6004-2 (Figure 5.30). Hold open rod wrench for Lyskov rack from the steering shaft. Remove the steering mechanism with the front suspension subframe.

Setting

Attach the steering mechanism to the front suspension subframe, install 2 new bolts and 2 noyh nuts and tighten the moment 45 Nm +45 ° +15 °. Attach 2 tie rod ends to the steering mechanism by means of devices KM-6004-2, and tighten the moment 90 Nm

NOTE Clean the threads on the rail and cover with a fixing composition.

Install 2 cover of the steering mechanism. Place 2 cover on the steering mechanism.

NOTE Make sure that the cover is located in the grooves of the steering rod and steering mechanism.

Attach 2 new retaining clamp to the steering mechanism by means of devices KM-J-22610. Install 2 mantle on the tie rod ends, using a new fixing bracket.

NOTE Make sure that the cover is located in the grooves of the steering rod.

Attach the electrohydraulic module with bracket to the front suspension subframe and tighten the nuts the moment 22 Nm Place electrohydraulic module with a holder on the steering mechanism and front suspension subframe.