The use of chains is allowed only on the leading wheels (front) of the bridge.
Use melkozvennye chain, the height of which, together with a connecting link in the chain of running surface and the inside of the tire is a maximum of 15 mm. NOTE Caps made of steel wheels may come into contact with the links of chains and damaged. Before installing the chain shields the wheels should be removed. Snow chains are allowed to use only up to 50 km / h and at snowless areas only for a short time, since the solid surface, they quickly wear out and can burst. Emergency Wheel Use of snow chains on the emergency wheel is not allowed. If you puncture to the front wheel drive with snow chains, emergency wheel should be installed on the rear axle and rear wheel - on the front.
Start the engine by using an auxiliary start cable Fig. 1.245. Auxiliary starter cables
If the battery is discharged, the engine can be run using the auxiliary start cable and battery of another car (Figure 1.245). It should exercise extreme caution. Any deviation from the instructions given may result in injury or damage in the explosion of battery and damage to electrical devices of both cars. Avoid sparks and open flame near the battery. The discharged battery can freeze at a temperature 0 ° C. Before you connect the auxiliary starter cable, you need to defrost frozen battery in a warm room. Do not expose the battery fluid in eyes, on skin, fabric and lacquered surfaces. The fluid contains sulfuric acid, which is in direct contact injuries. When working with battery wear protective glasses and clothing. Use the auxiliary battery constant voltage (12 V). Its capacity (Ah) must not be substantially less than the capacity discharged battery. The values of voltage and capacitance are listed on batteries. Should use an auxiliary starter cable with insulated pole clamps, a section not less than 16 mm 2, for diesel engines - 25 mm 2. The discharged battery will disconnect from the onboard network. Disable unnecessary consumers of current. During the whole procedure did not lean over the battery. Pole clamps a cable must not touch the terminals of another. During the start-up support vehicles must be fixed. Tighten the parking brake. Manual gearbox and a box Easytronic switch to the neutral position, the automatic transmission - in the position of R. Connecting the auxiliary battery Connect the cables to the one shown in Figure 1.246 sequence. 1. Connect the cable to the positive pole 1 auxiliary battery (the plus sign on the building or on the battery terminal). 2. The other end of the cable to the positive pole of 2 discharged battery (plus sign). 3. Connect the cable to the negative pole 3 auxiliary battery (minus sign).
110
