Included is level when you stop with the engine can be maintained. When stopped on an uphill gradient must necessarily tighten the parking brake or press the brake pedal. Do not hold the car when the transfer by increasing the engine speed to avoid overheating of the gearbox. For longer stops, such as in a traffic jam or on the move, turn off the engine. Before leaving the car at first turn on the parking brake, then - P mode and remove the ignition key. If you do not remove the ignition key, then long-time parking your car can happen discharging. Take out the key can be only when the gearshift lever is in position R. Interruption of power When a discharged battery gear lever does not switch from the position R. In the case of discharge of the battery, follow the procedure support the launch. If the reason was not the battery, unlock the gearshift lever. 1. Tighten the parking brake. Fig. 1.226. Lifting the hood selector lever
2. Release the latches on the cover behind the gear lever from the middle console and wrap it up (Fig. 1.226). Fig. 1.227. Detent selector lever
3. Use a screwdriver to push the stopper forward and bring the gear lever from position P (Fig. 1.227). 4. Put the gear lever cover in the middle console and secure it. When you switched on again, R is the lock. Eliminate the cause of interruption of power supply.
Trailer coupling, riding with trailer If the trailer coupling is installed on the car manufacturer, it is taken into account automatically. When riding with the trailer parking pilot is automatically disabled when installing the trailer plug the cable into the slot. NOTE When installing the rear trunk, such as a bike, remember that they are mounted near the sensors' parking pilot "and can disrupt the functioning of the system.
101
