Troubleshooting Table 34: Drive and Valve Error Codes Error Code
7
8
9
10
11
Error Description
Fault Cause
Fault Action
Corrective Action
Check front/left solenoid valve coil wiring and Both pumps will be disabled connector Left forward propel pump LH Front Pump solenoid at first. Then both pumps Check resistance of front/left solenoid wiring or coil valve coil and/or wiring could be run in limp mode solenoid valve coil (2.0 – 3.0 fault connection is open or short with no forward propel on left ohms at 70F between two track connector pins) Check controller2 connector and wiring Check front/right solenoid valve coil wiring and Both pumps will be disabled connector Check resistance of front/ Left reverse propel pump RH Front Pump solenoid at first. Then both pumps right solenoid valve coil (2.0 solenoid wiring or coil valve coil and/or wiring could be run in limp mode fault connection is open or short with no reverse propel on left – 3.0 ohms at 70F between two connector pins) track Check controller2 connector and wiring Check rear/right solenoid valve coil wiring and Both pumps will be disabled connector Right front/left solenoid RH Rear Pump solenoid valve at first. Then both pumps Check resistance of rear/ valve coil wiring and coil and/or wiring connection is could be run in limp mode right solenoid valve coil (2.0 connector open or short with no reverse propel on – 3.0 ohms at 70F between right track two connector pins) Check controller2 connector and wiring Check rear/left solenoid valve coil wiring and Both pumps will be disabled connector Right forward propel LH Rear Pump solenoid valve at first. Then both pumps Check resistance of rear/left pump solenoid wiring or coil and/or wiring connection is could be run in limp mode solenoid valve coil (2.0 – 3.0 coil fault open or short with no forward propel on ohms at 70F between two right track connector pins) Check controller2 connector and wiring Check center/bottom solenoid valve coil wiring and connector Check resistance of center/ Attachment tilt forward Bottom center valve solenoid Attachment tilt forward bottom solenoid valve coil solenoid valve B wire or valve coil, and/or wire function is disabled (5.0 – 5.6 ohms at 70F coil fault connection is open or shorted between the two connector pins) Check Controller2 connector and wiring
50940165/C0718
338
Printed in U.S.A.
