Models 1750RT/2100RT Tier 4 Engine Removal/Installation

Tier 4 Engine Installation

Model 1750RT (S/N 131001 and Up)

Model 2100RT (S/N 241001 and Up)

IMPORTANT: Always verify electrical connections are sound and strain relieved when static and to accommodate moving components and machine operation. Route, tie and clamp all wires and connections to avoid pinching, chaffing and damage consistent with factory design and practice.

1.Carefully lift engine (K, Fig. 354) into place using an engine hoist or other appropriate lifting device.

NOTE: Use caution when positioning engine (K) inside the engine compartment to prevent damaging hoses, components and wire harnesses.

Warning

Keep hands and feet clear when positioning the engine in the machine. Severe pinching/ crushing injury can occur.

NOTE: Install new screws (B, Fig. 355) for installation. Refer to the parts manuals for ordering information.

2.Install new screws (B) and washers (C) in both rear motor mounts (D). Torque to 298 Nm (220 lb.-ft.).

3.Secure fuel line (X) to left motor mount (D) using screw (F) and nut (G). Tighten securely.