Hydraulic Equipment

7.Start the machine and operate and test the lift/ tilt, travel drive functions.

8.Pressurize the auxiliary hydraulics circuits:

•Move the standard auxiliary control rocker switch on the joystick to the forward and reverse positions.

•If the machine is equipped with high-flow hydraulics, press the high-flow auxiliary hydraulics switches.

Warning

NEVER use your hands to search for hydraulic oil leaks when the machine is running. Use a piece of cardboard or paper if necessary to check for leaks when the machine is running. Escaping oil under pressure can be invisible and penetrate the skin causing serious injury. If any oil is injected into your skin, get medical attention immediately. Injected fluid MUST be surgically removed by a doctor familiar with this type of injury or gangrene may result.

Warning

ALWAYS wear safety glasses when checking for hydraulic fluid leaks when the machine is running. Escaping fluid under pressure can be invisible and can cause permanent eyesight damage if safety glasses are not worn.

9.Stop the machine and check the control valve installation for leaks. Repair/replace as necessary.

10.Check the level of the hydraulic oil in the reservoir. Add oil if necessary. Refer to “Checking Hydraulic Oil Level” on page131.