Golf 2015 ➤ , Golf Variant 2015 ➤ Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
3.5
Crankshaft, Measuring Axial Clearance
Special tools and workshop equipment required ♦ Dial Gauge Holder - VW387♦ Dial Gauge - 0-10mm - VAS6079Procedure – Attach the Dial Gauge - 0-10mm - VAS6079- with the Dial Gauge Holder - VW387- to the cylinder block and wagenap‐ olkswith AG do en AG. V agagainst es n w proximately 2 mm tension, set indicator crankshaft s k l ot g o yV ua counterweight. db r e ris
un le
Axial clearance: •
New: 0.07 to 0.23 mm.
•
Wear limit: 0.30 mm.
3.6
Crankshaft, Measuring Radial Clear‐ ance
Special tools and workshop equipment required ♦ Plastigage® Procedure Note
♦ Bearing shells that are worn down to the nickel layer must be agen lksw Vo by
Prote cted by
c o p yri gh t. C op yi
replaced.
ht rig py Co t.
r fo ng
♦ Do not interchange used bearings
rrectne s s o f i t to the co n form spec atio h re n wit i n thi sd o c um en
urposes, in part or in wh ole, cial p is n mer m ot p o c erm or e t a itte v i r d p
– Remove the crankshaft from the dial gauge and read the measurement.
an tee or ac ility ab y li an pt ce
ho – Push the crankshaft against ut the dial gauge by hand and set the dial gauge to “0”. ss a
– Remove the crankshaft bearing cap and clean the bearing cap and pins. AG.
– Place Plastigage® over entire width of bearing journal or into bearing shells. •
Plastigage® must rest in center of bearing shell.
3. Crankshaft
67
