C1.6 Clamping Sleeve Installation Position

Golf 2015 ➤ , Golf Variant 2015 ➤ Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015

3 - Bolt ❑ 20 Nm

4 - Bracket

Protected by copyright . Copying for pivate or commerci al pur po s e s , i

5 - Retaining Loop p a r t o r in w ho le, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does notguarantee or accept any liabilit y wi th res pect t o t h e c o r r e c t n e ss o f n ❑ Replace if damaged 6 - Rear Muffler ❑ Original equipment as one unit with rear muffler. For repairs, replace each separately ❑ Removing and installing. Refer to ⇒ “1.3 Muffler, Removing and Installing”, page 343 . ❑ Separating point. Refer to ⇒ “1.2 Exhaust Pipes/Mufflers, Separating”, page 342 . ❑ Exhaust System, Installing without Tension. Refer to ⇒ “1.4 Exhaust System, Installing without Tension”, page 345 . 7 - Rear Clamping Sleeve ❑ Before tightening, align exhaust system free of tension. Refer to ⇒ “1.4 Exhaust System, Installing without Tension”, page 345 . ❑ Installed position. Refer to ⇒ Fig. ““Installation Position for Rear Clamping Sleeve”“ , page 347 ❑ Tighten threaded connections evenly. ❑ Tightening specification. Refer to ⇒ Fig. ““Tightening Specification of Clamping Sleeve”“ , page 347 . r in format ion in this document. Copyright by Volkswagen AG.