Golf 2015 ➤ , Golf Variant 2015 ➤ Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015 11 - Secondary Air Injection Pump Motor - V101❑ Secondary Air Injection Pump Motor - V101- , Removing and installing. Refer to ⇒ “3.2 Secondary Air Injection Pump Motor V101 , Removing and Installing”, page 353 .
3.2
eo ra c
th au s s
pe rm itte d
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation; Overview - Noise Insulation . es, in part or in w l purpos hole ercia , is n m ot com
rrectness of i t to the co nform spec a t i h re o n in wit thi s
– Open the release -arrows- and remove the lines -1- from the Secondary Air Injection Pump Motor - V101- -2-.
ility ab y li an pt ce
un le
Removing
n AG. Volkswagen A
G do age Pump Motor Secondary Air Injection - es not g ksw Vol y ua b d ran V101- , Removing and Installing ise te r o
– Remove the nuts -arrows- and the Secondary Air Injection Pump Motor - V101- -1- with the bracket.
Prote cted by
♦ Refer to ⇒ “3.1 Overview - Secondary Air Injection System”, page 352
3.3
AG.
Tightening Specifications
agen lksw Vo by
c o p yri gh t. C op yi
Install in reverse order of removal. Note the following:
ht rig py Co t.
Installing
do c um en
r te o iva r rp fo g n
– Disconnect the connector -2- from the Secondary Air Injection Pump Motor - V101- .
Secondary Air Injection Solenoid Valve - N112- , Removing and Installing Caution
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure. Mandatory Replacement Parts ♦ Seal - Secondary Air Injection Solenoid •
The flange must not be separated from the Secondary Air In‐ jection (AIR) solenoid valve.
•
Both the AIR solenoid valve and the flange are replaced com‐ pletely.
Removing – Remove the air filter housing. Refer to ⇒ “3.2 Air Filter Housing, Removing and Installing”, page 294 .
3. Secondary Air Injection System
353
