Golf 2015 ➤ , Golf Variant 2015 ➤ Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015 Removing – Disconnect the Oxygen Sensor 1 after Catalytic Converter GX7- connector -1-. . Volkswage
n AG d oes not gu ara nte eo ra c
rrectness of i t to the co nform spec at i h re o n wit in t his
es, in part or in w l purpos hole ercia , is n m ot p om c r erm o e t a itte riv du p or nl f e g n
ility ab y li an pt ce
ss
AG agen ksw l o yV db ise r tho au
– Remove the Heated Oxygen Sensor -1- using a tool from the Ring Spanner 7-Piece Set - 3337- . Installing
Note the following when installing: Note
♦ Coat new oxygen sensors with an assembly paste. This paste
must not come into contact with oxygen sensor slots.
♦ For a used oxygen sensor, only coat threads with hot bolt
AG.
Tightening Specifications
agen lksw Vo by
Prote cted by c o p yri gh t. C op yi
location when installing. Do not the electrical wire connection come in contact with the exhaust pipe.
ht rig py Co t.
♦ The oxygen sensor wire must always be attached at the same
do c um en
paste. This paste must not come into contact with oxygen sensor slots. Hot bolt paste. Refer to the Parts Catalog.
♦ Refer to ⇒ “8.1 Overview - Heated Oxygen Sensor”, page 333 .
8. Heated Oxygen Sensor
335
