Golf 2015 ➤ , Golf Variant 2015 ➤ Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015 The Oxygen Sensor 1 before Catalytic Converter - GX10- is com‐ posed of: ♦ Heated Oxygen Sensor - G39♦ Oxygen Sensor Heater - Z19Removing – Disconnect the connector -2- of the Oxygen Sensor 1 before Catalytic Converter - GX10- .
– Remove the Oxygen Sensor 1 before Catalytic Converter GX10- -1- using a tool from the Ring Wrench 7-Piece Set 3337- . Installing Note the following when installing: Note ♦ Coat new oxygen sensors with an assembly paste. This paste
must not come into contact with oxygen sensor slots.
agen AG .V en AGcoat ♦ For a used oxygen sensor, threads with gonly does hot bolt swa
♦ Refer to ⇒ “8.1 Overview - Heated Oxygen Sensor”, page 333 .
8.3
Oxygen Sensor 1 after Catalytic Con‐ verter - GX7- , Removing and Installing
The Oxygen Sensor 1 after Catalytic Converter - GX7- is com‐ posed of: ♦ Oxygen Sensor after Three Way Catalytic Converter - G130♦ Heater For Oxygen Sensor 2 after Catalytic Converter - Z30Special tools and workshop equipment required
AG.
Prote cted by
Rep. Gr.24 - Multiport Fuel Injection
agen lksw Vo by
c o p yri gh t. C op yi
334
ht rig py Co t.
r fo ng
♦ Ring Wrench 7-Piece Set - 3337-
rrectne s s o f i t to the co n form spec atio h re n wit i n thi sd o c um en
urposes, in part or in wh ole, cial p is n mer m ot p o c erm or e t a itte v i r d p
Tightening Specifications
ility ab y li an pt ce
location when installing. Do not the electrical wire connection come in contact with the exhaust pipe. un le
♦
olksw k not l o V not come into contact with oxygen paste. This paste must gu by ar d sensor slots. Hot isebolt paste. Refer to the Parts Catalog. ante r o eo h ut ra asensor The oxygen wire must always be attached at the same c s s