Golf 2015 ➤ , Golf Variant 2015 ➤ Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015 ❑ Lubricate the high pressure line with engine oil ❑ Do not install a tensioned high pressure line (pay attention to cleanliness). 11 - Fuel Line Connections ❑ 20 Nm ❑ On vehicles without multiport fuel injection, a sealing plug is installed 12 - Clamp ❑ Replace after removing 13 - Bolt ❑ 5 Nm 14 - Fuel Line ❑ Fuel line to the intake manifold fuel injector fuel rail 15 - Vacuum Diaphragm for Channel Separating Plate 16 - Vacuum Hose 17 - Intake Manifold Runner Control Valve - N31618 - Intake Manifold Sensor - GX9❑ Consists of:
ility ab y li an pt ce
Manifold Absolute Pressure Sensor - G7119 - Bolt ❑ 5 Nm
20 - Intake Manifold ❑ Removing and installing. Refer to ⇒ “4.3 Intake Manifold, Removing and Installing”, page 304 .
rrectness of i t to the co nf o r m spec atio h re n in wit
es, in part or in w l purpos hole ercia , is n m m ot p o c erm or e t a itte iv r du rp o nl f e ng
Intake Air Temperature Sensor -
n AG. Volkswagen AG do es n wage s k l ot g o yV ua b d ran ir se tee o h t or G42- au ac ss
21 - Intake Manifold Runner Position Sensor - G336❑ After replacing or removing and installing, the Intake Manifold Runner Position Sensor - G336- must be adapted to the Engine Control Module - J623- using the ⇒ Vehicle diagnostic tester. 22 - Intake Manifold Nut ❑ 9 Nm 23 - Intake Manifold Bolts ❑ 9 Nm
ht rig py Co t.
25 - Low Fuel Pressure Sensor - G410❑ 15 Nm ❑ Must be bolted with the adapter -26❑ Removing and installing. Refer to ⇒ “5.4 Low Fuel Pressure Sensor G410 , Removing and Installing”, page 318 .
thi sd o cu m en
24 - Seal ❑ Check and replace if damaged
agen lksw Vo by
AG.
Prote cted by
c o p yri gh t . C op yi
26 - Adapter ❑ 15 Nm ❑ Must be bolted with the Low Fuel Pressure Sensor - G410❑ Replace O-ring 27 - O-Ring ❑ Replace after removing 28 - Clip ❑ For the locating point of the Low Fuel Pressure Sensor - G410- in the fuel rail.
4. Intake Manifold
303