5_108.bk Page 216 Thursday, October 4, 2001 11:45 AM
REPAIR INSTRUCTIONS Flywheel Installation
289
INSTALLATION
When installing the flywheel, insert two alignment studs into the flywheel mounting holes to aid in installation. Refer to Figure 289. 1. Position the flywheel on the rear of the crankshaft at the flywheel mounting surface. 2. Install flywheel mounting capscrews in the exposed mounting holes. At this time, tighten the capscrews finger-tight only. 3. Remove the two alignment studs and insert the remaining mounting capscrews.
Do not torque capscrews adjacent to each other in sequence as uneven flywheel alignment may result. Alternately torque capscrews on opposite sides of the flywheel. Figure 289 — Flywheel Installation
4. Torque the capscrews to 185 lb-ft (251 N•m), alternating from opposite sides to apply even pressure to the flywheel (use torque wrench J 24407, or equivalent).
Page 216
