Section 5. Troubleshooting
Toyota Orderpicker Model 7BPUE 15 Service Manual
Programmable Maintenance Tool
Programming You can change certain parameters using the PMT. See Table 5-7. All changes occur in "real time"; the parameters can be changed while the truck is in operation. 1. Turn the key switch OFF and disconnect the battery connector. 2. Remove the tractor cover. 3. Connect the PMT to the traction power amplifier. 4. Connect the battery and turn the key switch ON. 5. Press the program key to enter the Program mode. 6. Press either scroll display key until the parameter you want is the top line of the display. See Table 5-7. Table 5-7.
7. Press either change value key until the setting you want is displayed. The parameter is now set a t the value you selected. 8. If the display stops changing and you want to go further, press the more info key. If the display shows "Min. Limit" or "Max Limit," you have reached the factory set limit for that parameter. NOTE: The parameter may be dependent on another parameter. If so, the display will show this information. Changing the related parameter may allow you to change the setting further.
See "Definitions" on page 5-17.
Traction Power Amplifier Parameters
M 3 RESTRAINT
neutral with the deadman switches closed. With neutral braking set a t 0%, the truck coasts to a stop when the throttle is in neutral (released).There is no plugging force applied. When set to loo%, the power amplifier applies ing force when the throttle is in neutral
00700-CL222-05, 1 5 March 2005
