6.1.2. STEERING UNIT COMPONENTS ASSEMBLY
S76W931A
S76W933A
REAR HSTAXLE
S76W963A
REAR BRAKE AXLE
3. While holding the other side of the centering spring using pliers, insert the spring into the slot hole with a special service tool still attached on the opposite side. Position the spring to the end through the sleeve and spool. 2. With the centering spring aligned, adhere one side of the spring closely to the groove of a special service tool, and insert the centering spring. Align each spring (3 EA) with their convex surfaces touched each other and their notched grooves facing downward.
HYDRAULIC ELECTRIC & DIAGNOSIS SYSTEM
HYDRAULIC STEERING SYSTEM
STEERING SYSTEM FRONT AXLE
FRONT BRAKE AXLE
S76W932A
S76W934A
A/C AND INDEX HEATER
4. Align the spool and sleeve so that their ends are parallel, and insert the pin into the sleeve hole not to be protruded.
10-22280 of 450
DR72-W00
Dealer Copy -- Not for Resale
1. Fit the spool (2) into the sleeve (1), and position the spool so that its hole is aligned with the centering spring slots. Set the direction referring to the stamped mark as shown in the figure.
TRANSMI SSION HST
TRANSMI SSION TRANSMISSION
CLUTCH
ENGINE
GENERAL
SAFETY FIRST
STEERING SYSTEM - DISASSEMBLY, SERVICE AND ASSEMBLY
