STEERING SYSTEM - DISASSEMBLY, SERVICE AND ASSEMBLY

6.1.3. RELIEF VALVE DISASSEMBLY AND ASSEMBLY

6.2 STEERING CYLINDER REMOVAL

1. Remove the outer plug (1) using a hex wrench. Mark its original position before unscrewing it for pressure setting.

2. Remove the spring (2) and the spool (3).

1. Install the safety jack to the front axle and front axle frame. Then, remove one front tire (1).

3. Install in the reverse order of removal.

4. Check the O-ring on the outer plug, and replace it with a new one if damaged. Grease the surface before installation.

5. If the control screw setting does not work, measure the pressure and turn the screw to set the pressure to the specified pressure 110~115 Kgf/cm² (1,564 ~ 1,635 psi).

6. The pressure can be measured by disconnecting the hydraulic hose on the steering cylinder side, and fitting a pressure gauge.

Or, ref er to the section "4.1 STEERING UNIT RELIEF VALVE PRESSURE".

2. Unscrew the ball joint end mounting nut (RH/LH) (1) to separate the ball joint end (2) from the front axle case.

Caution

• Replace the split pin of the ball joint end with a new one during installation.