C. DEEP CONTACT
CLUTCH
ENGINE
GENERAL
A. TOE CONTACT
SAFETY FIRST
FRONT AXLE - MEASUREMENT AND ADJUSTMENT
•
Collar 4 thickness : Increase Collar 5 thickness : Decrease Shim 2 thickness : Increase
If the contact mark is on the deep of the ring gear teeth, push the ring gear away from the pinion and push the pinion into the ring gear (if necessary) to maintain the backlash. Then, measure the backlash for the final time.
TRANSMISSION TRANSMI SSION
If the center of the contact mark is too close to the toe of the tooth, push back the pinion shaft and push in the ring gear to the pinion direction so that the back lash is maintained. Then, measure the backlash.
TRANSMI HST
•
T46W821A
Dealer Copy -- Not forSSION Resale
T46W819A
REAR HSTAXLE
Shim 2 thickness : Decrease Collar 4 thickness : Decrease Collar 5 thickness : Increase
D. TIP CONTACT
FRONT STEERING AXLE SYSTEM
FRONT BRAKE AXLE
REAR BRAKE AXLE
B. HEEL CONTACT
Collar 4 thickness : Decrease Collar 5 thickness : Increase Shim 2 thickness : Decrease
DR72-W00
237 of 450
•
If the contact mark is on the deep of the ring gear teeth, pull the ring gear toward the pinion and pull out the pinion from the ring gear (if necessary) to maintain the backlash. Then, measure the backlash for the final time. Shim 2 thickness : Increase Collar 4 thickness : Increase Collar 5 thickness : Decrease
HYDRAULIC STEERING SYSTEM
If the contact mark is close to the heel of the ring gear teeth, push the pinion shaft toward the ring gear and push the ring gear away from the pinion so that the backlash is maintained. Then, measure the backlash.
A/C AND INDEX HEATER
•
T46W822A
HYDRAULIC ELECTRIC & DIAGNOSIS SYSTEM
T46W820A
9-13
