CONTROLS/INSTRUMENTS/ACCESSORIES
ROTARY BEACON (specific to certain countries) Template Name: OM_1_col Template Date: 1994_04_29
The rotary beacon must be installed for road travel. See “Road travel” in the “Job Site and Road Operation” Section. STEP 1
STEP 3
PG02700
PG02702
TRIM THIS EDGE
Remove the protective cap from the end of the tube located at the top of the cab. STEP 2
Tighten the wing nut. The rotary beacon is turned on and off by the switch on the instrument panel. IMPORTANT: The rotary beacon must be on when travelling. IMPORTANT: When removing the rotary beacon, make sure to put the cap back on the end of the tube.
Alt= to hide template information Alt+ to display template information
NOTE: To replace the bulb see “Replacing a bulb” in the “Electrical System” Section. PG02702
Place the rotary beacon on the end of the tube.
114
TRIM THIS EDGE LEFT PAGE
