CLAAS COMBINE VARIANT 260 VARIANT280 ADJUSTING THE ENDLESS BELTS Assembly instructions Manual_DE_EN_

Hydraulic tests

Hydraulic tests TENSIONING CYLINDERS FOR UPPER AND LOWER ARMS Recommendations For the following tests with recommend the use of a tractor with the following features: – Oil supply capacity: 50 l/min, – Oil temperature: 50 °C

Preparing the machine Danger! Before starting work in the hydraulic system shut the engine down, pull out the ignition key and block the machine against rolling. Relieve the pressure in the hydraulic system.

Environment! Dispose of hydraulic oil acc. to applicable legal regulations.

General cylinder inspection Check the function of the pressure gauge at the front of the machine.

299 498.0 - ABA Riemen - VRT 260/280

Turn static files into dynamic content formats.

Create a flipbook

CLAAS COMBINE VARIANT 260 VARIANT280 ADJUSTING THE ENDLESS BELTS Assembly instructions Manual_DE_EN_

Articles inside

Fuite interne dans le bloc

Limiteur de pression 10 bars

Vérins de tension des bras supérieur et inférieur

10. Contrôles

9. Alignement des bras supérieur et inférieur

6. Réglages - porte fermée

7. Réglages - porte ouverte

8.Ajustage

5. Guidages des courroies - Contrôles

3. Position initiale - Rouleau N°7 - Porte fermée

4. Position initiale - porte ouverte

2. Préparation de la presse

1. Généralités

Internal leakage in hydraulic block

Pressure relief valve 10 bar

Tensioning cylinders for upper and lower arms

10. Check

8.Setting

7. Adjustment - open tailgate

9. Aligning upper and lower arms

6. Adjustment - closed tailgate

Innere Leckage im Hydroblock

4. Initial position – tailgate open

2. Preparing the baler

3. Initial position – roller 7 – tailgate closed

5. Checking the belt guides

Druckbegrenzungsventil 10 bar

1. General notes

Spannzylinder von unterem und oberem Arm

7. Einstellungen - offene Heckklappe

8.Einstellung

4. Ausgangsposition – geöffnete Heckklappe

6. Einstellungen - geschlossene Heckklappe

9. Ausrichten von unterem und oberem Arm

2. Presse vorbereiten

5. Prüfung der Riemenführungen

3. Ausgangsposition – Walze 7 – geschlossene Heckklappe