Template Name: OML_2_col Template Date: 1994_04_22
907871
844/642 Telehandler
Alt= to hide template information Alt+ to display template information
INTERMEDIATE BOOM
INTERMEDIATE BOOM INSTALLATION
STEP 22 2
2
1
1
STEP 18
2
1 1 2 G1630MP
Reinstall the two bottom slide pads on the front of the outer boom, using the lockplates (1) and bolts (2). Use Loctite 271 (red) Thread Lock (or equivalent) on the threads of the bolts and tighten to 30 ft.-lbs. (41 Nm) torque. Bend each end of the lockplates up.
G1632MP
Apply grease to the inside bottom and top surfaces of the outer boom where the pads of the intermediate boom section will contact when assembled. Use a brush attached to a rod or pole to reach inside the boom.
STEP 23 Using the hois t and li fti ng s trap, lower t he intermediate boom slightly.
STEP 19
STEP 24
Install the intermediate boom section into the outer boom as far as possible.
STEP 20
G1628MP
Reinstall the two top slide pads and shims on the front of the outer boom using the bolts and washers. Use Loctite 271 (red) Thread Lock (or equivalent) on the threads of the bolts and tighten to 30 ft.-lbs. (41 Nm) torque.
G1645MP
Lower the hoist and move the lifting strap to the end of the intermediate boom section, apply upward pressure and slide the intermediate boom section into the outer boom until there is approximately 12 inches (30 cm) left sticking out the outer boom.
STEP 21 Using the hoist and lifting strap, apply upward pressure to the intermediate boom. PRINTED IN U.S.A.
706-4
913250
