844/642 Telehandler ENGINE

STEP 102

STEP 105

Start the engine and run until the coolant has reached operating temperature. Adjust the throttle cable linkage until the engine ranges in speed from 800 to 850 RPM at low idle to 2600 to 2700 RPM at high idle.

STEP 106

Check the hydraulic functions and transmission for proper operation. Shut off the engine and check for leaks and correct fluid levels.

Install the rear hood. Complete Steps 12 and 13 of Section 800 for the correct procedures.

STEP 103

Connect the negative (-) battery cable to the battery.

STEP 104

See the Engine Operation and Maintenance Manual for the specified engine coolant and crankcase oil, and correct levels.

Fill the radiator and engine block with the specified coolant.

Fill the crankcase with the specified oil.

Bleed the fuel system by following the procedures in the Service/As Required section of the Engine Operation and Maintenance Manual.