Cab overview, use, operation Putting the drive interlock back into operation again ☞ Proceed as follows: • Press the (*) key for 2 seconds (ignition key in position OFF) until two short acoustic signals are given for confirmation ➥ The system is enabled again. The code must be entered to start the diesel engine.
Interruption of drive interlock power If the drive interlock was enabled before electric power was interrupted, short acoustic signals are given upon switching on the keypad (similar to those that are given when entering the wrong code four times). In this case, wait until the acoustic signals are no longer given. Then disable the drive interlock with the personal or main code. The LED does not come on if the drive interlock was disabled. The diesel engine can be started before the LED starts flashing again. If the drive interlock was out of operation, this status remains unchanged and the LED flashes slowly.
Drive interlock maintenance The drive interlock does not require any maintenance. • Protect the keypad and the control unit from heat and humidity
1.9 Battery master switch (option) Switching the battery master switch ON and OFF The battery master switch separates the entire electrical system from the battery and ensures protection against unauthorised machine operation. Before performing repair work on the electrical system, separate the battery from the electrical system with the battery master switch. The battery master switch is located next to the fuel filter
Caution! In order to avoid damage to the additional heating (option), separate the battery master switch only after the heater does not run at all any longer! Fig. 11: Battery master switch
☞ Interrupting power supply • Turn and remove the key of the battery master switch (notched position)
☞ Switching on power supply • Insert the key in the battery master switch • Turn the key to the notched position
1-16
Serv-HB 40702 – Edition 2.0 * 407-02s0310_a4_Übersicht-Bedienung.fm
