Attachments Removal and Installation of Boom Cylinder ・ Stop the machine on a level location with good footing. ・ Be sure to stop the engine before beginning work. ・ When working together with others, always be sure to exchange signals and pay adequate attention to safety. Caution ・ Always wear protective devices (protective eyewear and safety shoes, etc.) when working with a hammer. ・ Be sure to inspect the nylon sling and other lifting equipment before beginning work. ・ Do not stand or pass under the suspended load.
Items to prepare • Wrenches (19 mm, 30 mm, 36 mm) • Crowbar • Wire rope (with the required lifting capacity) • Crane (with the required lifting capacity)
AL
• Marking pen • Caps • Plugs
RN
• Hammer • Striking rod • Grease
• Crossties • Wire
1. Removal of Boom Cylinder
IN
TE
• Rag • Cleaning fluid
CO US N F E ID O E F N TS TI M AL GL : F O OR BA T L H
E
• When removing only the boom cylinder, put the attachments in the temporary decommissioning posture.
• When removing as far as the boom, first remove the bucket, bucket cylinder, arm, and arm cylinder according to their respective removal procedures. Bring the boom top in contact with the ground. [1] Use a crane and nylon sling (1) to secure the boom cylinder (2).
397
1
Nylon sling
2
Boom cylinder (right)
2
Boom cylinder (left)
RSM-13-15-001E 17
