Charge Fuel Pump Filter

[7] Place a striking jig (9) against the master pin (7) and hit it with a hammer (8) to push the master pin out.

[8] Open the shoe (2) to the rear.

[9] Use a wrench (19 mm) to remove the 4 bolts (10), and then remove the cover (11).

2 Shoe 7 Master pin 8 Hammer 9 Striking jig 10 Bolt 11 Cover

[10]Use wrenches (27 mm for drain hose, 36 mm for high-pressure hose) to remove the drain hose (13) and 3 high-pressure hoses (12). •Be sure to use plugs on the removed drain and high-pressure hoses.

[11]Use a wrench (17 mm) to remove the pilot hose (15) and elbow joint (14) as in the diagram.

[12]Attach the wire rope (17) to the travel motor (16) as in the diagram.

Adjust the wire rope so that it is located at the center of mass and lift it with the crane so that it is slightly tensed.

12 High-pressure hose 13 Drain hose 14 Elbow joint 15 Pilot hose 16 Travel motor 17 Wire rope