TE R IN E
CO US N F E ID O E F N TS TI M AL GL : F O OR BA T L H
[16] Draining reduction gear lubricating oil Before disassembling the reduction gear section, use the tap for securing the flange (1-1) and mount two eyebolts in opposing positions to lift the reduction gear with a crane. Remove the plugs (29) in the 2 locations and drain the reduction gear lubricating oil. Cautions: a. Prepare an oil pan before performing work. b. Do not lift to too high position when lifting with the crane. Perform work with the reduction gear at the lowest possible position (at about knee height). [17] Removal of cover Loosen and remove the hexagon socket head bolts (28). After this, remove the cover (27). Cautions: Use the following procedure when removing the cover. a. Liquid packing has been applied between the cover and housing (4). For this reason, it is difficult to remove the cover. Loosen the socket head bolt and strike the top and side of the cover with a plastic hammer after removing the bolt. b. Insert a flathead screwdriver in the gap between the cover and housing and remove the cover. [18] Removal of thrust plate Remove the thrust plate (26) from the thrust plate (23) top surface.
NA L
Travel Unit
33
RSM-13-02-001E 27
