Transmission Overhaul Procedures-Bench Service How to Assemble Clutch Housing / Front Cover Special Instructions None
Special Tools •
Typical Service Tools
•
Bearing Driver (Tool ref. ID T10)
Procedure 1.
Thoroughly clean and remove all traces of old hardened sealant and debris from the front cover, main transmission sealing surfaces and oil passages, prior to beginning the reassembly process.
2.
Install the oil dam plate and retaining capscrew inside the bearing bores, tighten capscrew to 20-23 lb-ft (27-31 Nm).
3.
Install the oil trough and two retaining capscrews. Tighten to 20-23 lb-ft (27-31 Nm).
4.
Coat the bearing rollers with transmission lube.
Note: The orientation of the snap ring groove should be facing downward. 5.
129
Install the front countershaft bearings into the bearing bores using bearing driver (Tool Ref. ID T10).
