Lifting the Machine Using a Crane or Hoist Note: Single-point and four-point lift kits are available for lifting the machine. Contact you dealer for more information.
Contact your dealer for available lift kits for the machine. Do not lift the machine without an approved lift kit installed.
WARNING
Before lifting, check the lift kit for proper installation. Securely fasten the lifting gear to the machine at the designated lift points. When using any lift kit, follow the directions included with the lift kit. Never allow riders in the operator’s compartment while the machine is lifted. Keep clear of suspended loads. Keep everyone a safe distance away from the machine while it is lifted. The machine may only be crane-lifted with an empty bucket, empty pallet forks, or with no attachment. Never lift the machine with any other attachment installed. Never lift the machine with a load in the bucket or on the pallet forks. Lift equipment used and its installation is the responsibility of the party conducting the lift. All rigging MUST comply with applicable regulations and guidelines. 1. If a bucket is attached, make sure it is emptied. If pallet forks are attached, remove any load from the pallet forks. 2. Raise the arm rests/safety bars to apply the parking brake and lock out the hydraulic functions. 3. Turn off the engine and remove the ignition key. Close the doors and the engine cover. Do not allow anyone to stay in the cab. 4. Using suitable lift equipment, hook into the lift kit lifting points. Adjust the length of the slings or chains so the machine is level when lifted. Note: The machine may be slightly off level (10 degrees max.) when lifted. 5. Center the hoist over the ROPS/FOPS. To prevent shock loading of the equipment and excessive swinging, slowly lift the machine off the ground. Perform all movements slowly and gradually. As needed, use a tag line to help position the machine and keep it from swinging.
117
50950264/D0819
