Final Shutdown / Decommissioning

Important: Dispose of all materials properly. Used oils/fluids are environmental contaminants and may only be disposed of at approved collection facilities. Never drain any oils/fluids onto the ground, dispose of in municipal waste collection containers, or in metropolitan sewer systems or landfills. Check state and local regulations for other material disposal requirements.

If the machine will no longer be used as intended, shutdown, decommission and dispose of it according to the valid regulations.

Before Disposal

1.Shut down the machine according to valid regulations regarding proper shutdown.

2.Park the machine on level, dry ground. Ensure the surface can support the weight of the machine. Ensure the location is protected against access by unauthorized persons.

3.Move the throttle to the low-idle position and allow the engine to cool for approximately 2 minutes.

4.Shut off the engine.

5.Move the lift/tilt and if equipped, the Power-A-Tach® quick attach control(s) to verify that the controls do not cause movement of the lift arm or hitch.

6.Raise the arm rests/safety bars to apply the parking brake and lock out the hydraulic controls.

7.Switch off all electrical switches.

8.Unfasten the seat belt, remove the ignition key and take it with you.

9.Ensure the machine poses no dangers in the place where it is standing.

10.Ensure the machine cannot be operated after shutdown until further disposal.

11.Ensure no environmentally hazardous materials, fluids and/or fuel can escape the machine.

12.Specifically check for leaks from the engine, the hydraulic system and the coolant system.

13.Remove any dirt and/or debris from the engine compartment, the chassis and the cylinder rod surfaces.

14.Remove the battery.

15.Lock the cab door, the storage compartment, the battery and hydraulic filler compartments and the engine compartment. Remove the key(s) and take it/them with you.

Machine Disposal

Make sure all materials are disposed of in an ecologically sound manner.

Recycle the machine in accordance with the current state of the art at the time of recycling. Observe all accident prevention regulations.

Dispose of all parts at the at the recycling sites specific to the material of the part. Take care to separate different materials for recycling.

Dealer Services

Service of the following components require special tools, skill and knowledge are not part of normal maintenance and are not included in this manual. Service of these components should only be performed by an authorized dealer:

•Engine service not included in this manual:

•Hydrostatic components.

•Hydraulic system pumps.

•Valves.

•Cylinders.

•Electrical components (other than the battery, relays and fuses).