F-code
PS Version no
001
Section
C-code
S1.1 1700 Drive Motor Service T-code
392,CMX,RMX,HMX,TMX
2.7. Assembly 2.7.1. Field Coil Installation Good solder connections are important due to the vibration characteristics encountered by these motors which can cause cold or poorly soldered connections to break.
Prior to installing the field coils the connections which require soldering should be buffed or wire brushed clean to remove any oxidation. The connections should then be tinned with a soldering iron. NOTE! We do not recommend using a soldering gun or torch. Soldering guns cannot provide the heat concentration required and soldering torches can damage the insulation.
After field coil installation connect the solder joint making sure the solder is flowing properly to avoid a cold soldered joint.
Pole Shoe Screw Removal & Installation (Field Coil Removal & Installation) Continue assembly in the reverse of disassembly paying particular attention to the following points. 2.7.2. Bearing Installation 1. Whenever ball bearings are pressed into an end head or onto a shaft always press against the race that is absorbing the pressure. Press on the outer race when installing into end heads. © BT Products
Return
Service Manual
1997-09-22
91
