Assembly

Inlet Port

2

3

4 1

5

6

4. Assembly

F-code Section C-code

PS S7.0 7310 Lift Cylinder

Version no T-code

000 RMX,HMX,CMX

NOTE!CLEANLINESS! Perform procedures in a clean environment. Make sure all parts are cleaned before disassembly and kept clean during assembly.

1.All parts should be cleaned and dried thoroughly.

Metal parts should be lightly oiled prior to reassembly.

WARNING

Be extremely careful when working with solvent. Even a small explosion or fire could cause injury or death.

WARNING

Compressed air used for cleaning MUST be reduced to less than 30 psi. and then only with effective chip-guarding and personal protective equipment.

2.Install new rod seal (5) in cylinder body (2). Install new rod wiper (6) with lips facing inward to bottom of cylinder body (2). 3.Place new retainer ring (3) in groove of cylinder rod (4). 4.Oil outside of cylinder rod (4) and carefully insert in cylinder body (2). 5.Push cylinder rod (4) in cylinder body (2) until retainer ring (3) and cylinder rod (4) can be viewed through inlet port. 6.Using a screwdriver through cylinder body (2) inlet port, taking care not to harm port threads, slide retainer ring (3) in small groove. Rotate cylinder rod (4) and make sure retainer ring (3) is in the small groove all the way around cylinder rod (4). 7.Extend cylinder rod (4) to the fully out position to make sure retainer ring (3) is locked in place.