Assembly

F-code Section C-code

PS S3.4 3560 Stabilizing Caster

Version no T-code

000 392,393,394,CMX,HMX

1.3. Assembly

NOTE!CLEANLINESS! Perform procedures in a clean environment. Make sure all parts are cleaned before disassembly and kept clean during assembly.

1.All parts should be cleaned and dried thoroughly.

Metal parts should be lightly oiled prior to reassembly.

WARNING

Be extremely careful when working with solvent. Even a small explosion or fire could cause injury or death.

WARNING

Compressed air used for cleaning MUST be reduced to less than 30 psi. and then only with effective chip-guarding and personal protective equipment.

2.Install ball bearings (12) and spacer washers (11) in wheel(s) (13). 3.Install new felt seal (3) into groove on yoke (4). 4.Install thrust bearing (2) on shaft of base (1). Slide base (1) though hole in yoke (4) making sure that the felt seal (3) is not damaged. 5.Press roller bearing (14) on shaft of base and install washer (7) and slotted nut (8). Tighten slotted nut (8) while rotating base (1) around yoke (4) until base (1) can not move. Back off slotted nut (8) one turn to nearest hole and install roll pin (9). 6.Tap hub cap (10) on over slotted nut (8). 7.Install wheel assembly in yoke assembly and slide axle (5) though yoke (4) and wheel (13). Install washers (15) and secure with cap screw (16). 8.Grease all grease fittings.