Removal

F-code Section C-code

PS S3.3 3540 Support / Swivel Wheels

Version no T-code 001 HMX

1.1. Removal

NOTE!CLEANLINESS! Perform procedures in a clean environment. Make sure all parts are cleaned before disassembly and kept clean during assembly.

1.Park the truck on a level surface and make sure parking brake is applied.

WARNING

Be extremely careful when working with solvent. Even a small explosion or fire could cause injury or death.

WARNING

Compressed air used for cleaning MUST be reduced to less than 30 p.s.i., and then only with effective chip-guarding and personal protective equipment.

2.Release pressure in hydraulic system by pressing the lowering button on steering control handle. 3.Disconnect battery from unit to prevent accidental operation. 4.Raise and block drive end of truck so casters wheels (8) are 2 - 3 in. [50 - 75 mm] off the floor. 5.Open access door fully. 6.Release pressure on springs (10) before removing caster assembles (8) from torsion bar (6).

WARNING

Risk of injury. Spring pressure is under spring base when unbolted spring base may fly free and injury or kill. Release spring tension before removing spring base mounting bolts.

7.Remove four cap screws (7) and nuts (9) securing caster assembly (8) to torsion bar (6).

F-code Section C-code

PS S3.3 3540 Support / Swivel Wheels

Version no T-code 001 HMX

8.Remove caster assembly (8) from truck. 9.Before disassembly, thoroughly clean exterior of the caster assembly (8) in a cleaning solvent to remove all contamination.

Be extremely careful when working with solvent. Even a small explosion or fire could cause injury or death.

WARNING

WARNING

Compressed air used for cleaning MUST be reduced to less than 30 p.s.i., and then only with effective chip-guarding and personal protective equipment.