Controller Adjustments

F-code Section C-code PS S5.8 5460 12 Volt Transistor Controller

Version no T-code 000 RMX

Acceleration Adjustment CW-FASTER Acceleration

Plug Current Adjustment CW-HIGHER Plugging Current

2.11. Controller Adjustments

The figure on the left shows location of PMC controller adjustment potentiometer. To make adjustment: 1.Remove socket head screws (1/8 in. Allen) for the adjustment you want to make. 2.Adjust the small internal potentiometer with a small trim pot adjustment tool. These are 270 degree turn potentiometers.

3.Replace the socket head screw and nylon seal washer. Tighten screws to 8 in-lb. 4.Both of these adjustments can be made to suit the operator.

Higher plugging current will mean a shorter stopping distance when plugging. This distance should not be shorter then 10 feet.

NOTE! If the proper tool is NOT used to adjust these potentiometers, it is possible to damage printed circuit board causing controller to fail.