Disassembly

F-code Section C-code

PS S3.4 3560 Stabilizing Caster

Version no T-code

000 392,393,394,CMX,HMX

1.1. Disassembly

NOTE!CLEANLINESS! Perform procedures in a clean environment. Make sure all parts are cleaned before disassembly and kept clean during assembly.

1.Before disassembly thoroughly clean exterior of the caster assembly in a cleaning solvent to remove all contamination.

WARNING

Be extremely careful when working with solvent. Even a small explosion or fire could cause injury or death.

WARNING

Compressed air used for cleaning MUST be reduced to less than 30 psi. and then only with effective chip-guarding and personal protective equipment.

2.Remove screw (16) and washers (15) securing axle (5) in yoke (4). Drive axle (5) from yoke (4) slide though wheel assembly. 3.Remove hub cap (10), roll pin (9), slotted nut (8), washer (7), and roller bearing (14) from yoke (4). 4.Separate base (1) and yoke (4) removing felt seal (3) and thrust bearing (2). 5.Remove spacer washers (11) and ball bearings (12) from wheel (13).