F-code
Section
C-code
PS S5.8 5460 12 Volt Transistor Controller Version no
T-code
000
RMX
2.11. Controller Adjustments Acceleration Adjustment CW-FASTER Acceleration
The figure on the left shows location of PMC controller adjustment potentiometer. To make adjustment: 1. Remove socket head screws (1/8 in. Allen) for the adjustment you want to make. 2. Adjust the small internal potentiometer with a small trim pot adjustment tool. These are 270 degree turn potentiometers. NOTE! If the proper tool is NOT used to adjust these potentiometers, it is possible to damage printed circuit board causing controller to fail.
3. Replace the socket head screw and nylon seal washer. Tighten screws to 8 in-lb. 4. Both of these adjustments can be made to suit the operator. Plug Current Adjustment CW-HIGHER Plugging Current
184
Return
Higher plugging current will mean a shorter stopping distance when plugging. This distance should not be shorter then 10 feet.
Service Manual
1997-07-15
