Operating instructions
F106.6 / F106.6A / F156.6 / F156.6A
Changing a wheel
40001396.00-en
Read and observe:
x Tighten the wheel nuts by hand.
"Wheels and tyres - Safety instructions".
x Remove the supports under the lifted axle and lower the axle.
"Tyre pressure instructions".
x Tighten the wheel nuts crosswise with the prescribed torque. Torques cf. "Fastening of wheels".
-
Safety
x Park the machine on firm and level ground. x Block the articulated joint. x Apply the parking brake. x Loosen the wheel-nuts on the wheel to be replaced by about one turn. x If a rear wheel is damaged, raise the relevant side of the machine with the blade, turning the blade in such a way that one end of the blade is in front of the damaged wheel. Then raise the machine with the appropriate lifting cylinder. x If a front wheel is damaged, raise the machine with the blade or with the front grading blade (optional equipment). x Prop up the raised axle with squared timber so that it cannot sink back down. x Secure the machine as described under "Securing the machine". x Deflate the tyres. x Unscrew the wheel nuts and take off the wheel, taking care not to damage the threads of the wheel nuts. x Do not lose the centering rings, spring washers and wheel-nuts. Reuse them when refitting the wheel. x Fitting the new wheel: - Inflate the tyre with a pressure of approx. 1 bar. - Observe the instructions set out under "Tyre tread position". - Be sure not to damage the threads of the wheel studs.
231
x Inflate the tyres with the correct pressure. See "Tyre inflation pressures" and "Tyre pressure Safety instructions". x Check the wheel nuts after 5 operating hours with a torque wrench for tightness.
Fastening of wheels Check the wheel nuts for tightness after 5 OPERATING HOURS and retighten using a torque wrench. Check all wheels in accordance with servicing plan W for tightness. Flat collar nut with spring washer black or galvanized
450 Nm
Flat collar nut with pressure plate black or galvanized
500 Nm
