F-code
Section
PS S5.14 Micro Switches
C-code
5511
Version no
T-code
000
395/396/397/398/399
2. Lift Limit Override Switch (S33) Optional
Lift Limit Override Switch
The lift limit override switch (S33) is located in the switch cluster to the left of key switch on the pod. The lift limit cutout height is a programmable parameter setting on the main electronic card. If the lift limit with override option is available, pressing the switch on the dash will allow the lift to function above the cutout height. As long as the carriage remains above the preset cutout height, the operator can lift and lower without pressing the override switch again. If the carriage drops below cutout height or hydraulic system is inactive for a set time, the override switch must be pressed again to reactivate lift.
2.1. Removal 1. Turn the key switch OFF and disconnect battery connector from the truck. 2. Loosen pod and remove lower control pod panel to allow access to wiring harness connection at switch cluster. 3. Pull two wires off tabs on back of switch. 4. Unscrew nut securing switch in switch cluster. 5. Lift switch from switch cluster.
2.2. Installation 1. Place a new switch in the switch cluster. 2. Secure switch with nut. 3. Attach two wires to tabs on back of switch. 4. Secure pod to truck. 5. Connect battery connector to the truck. 6. Check operation of truck, then return truck to service.
366
Return
Master Service Manual
2000-08-04
