1 minute read
Control Pod
from BT Electric Electrical Stand-Up Rider Truck RRX35/45 RDX30 RSX40/50 Master Service Manual 306756-000
F-code Section C-code PS S4.0 4110 Steering Arm / Wheel / Lever
Version no T-code 001 395/396/397/398/399
1. Control Pod
1.1. Removal
1.Park truck on level surface. 2.Turn key switch to OFF and disconnect battery connector from the truck. Block truck. 3.Remove dash retaining screws (see page100). 4.Remove adjusting lever (23) and washer (27). 5.Lift pod assembly. 6.Lift dash approximately 6 inch (152.4 mm) to access controls pod's wiring harness connectors. 7.Disconnect harness and remove control pod.
1.2. Installation
1.Route control pod wiring harness through dash. 2.Connect control pod harness to truck’s main wiring harness. 3.Install adjusting lever (23) and washer (27). 4.Install dash.
