1 minute read
Hydraulic Filter
from BT Electric Electrical Stand-Up Rider Truck RRX35/45 RDX30 RSX40/50 Master Service Manual 306756-000
F-code Section C-code PS S6.2 6131 Hydraulic Filter Assembly
Version no T-code 000 395/396/397/398/399
1. Hydraulic Filter
1.1. Removal
NOTE! It is recommended that hydraulic fluid be drained from hydraulic tank prior to replacing filter. 1.Lower carriage fully to ensure all hydraulic pressure is relieved. 2.Turn key switch OFF, and disconnect battery connector from the truck. 3.Remove dash (see page100). 4.Remove blue cover on filter adapter collar. Filter is attached to the bottom of the blue cover. 5.Remove filter by pulling straight down to snap it out of latch.
1.2. Installation
1.Snap filter onto blue cover. 2.Install cap and filter assembly in hydraulic tank. 3.Test operate truck. 4.Check hydraulic fluid level and refill as needed. 5.Replace dash. 6.Connect battery connector to the truck. 7.Return to service.
